Filter
Top Products
1-7
User channels
You can recall user channels through the keyboard by channel numbers. Once a channel is
selected with the keyboard, the channel can be changed with the [FREQ/CH] control.
For how to write user channels, see Chapter 3. 199 user channels ( 0-01 to 0-99 and 1-00 to 1-
99) can be programmed in addition to ITU channels.
To call the channel 1-20, for example:
Tx only
Press [TX], [CH], [1], [2], [0], [ENT]
RX only
Press [RX], [CH], [1], [2], [0], [ENT]
TX and RX paired
Press [CH], [1], [2], [0], [ENT]
Note: The standard sets provide readout of Rx CH No. and Rx frequency in kHz. When trans-
mitting, Tx CH and Tx freq. are displayed. Pressing the [ENT] key displays both Tx and Rx
frequencies.
R
02
4
6810
S
LOW
J3E
AGC NB SWEEP
SIMP
—
Rx band
Rx CH
Frequency
Figure 1-5 Sample user channel (Rx)
• The [CURS/2] key shifts the cursor to band or channel number.
• To change channel number use the [FREQ/CH] control; it changes the number above the
cursor, a band or channel designator.
• The [ENT] key temporarily displays both Tx and Rx frequencies.