Filter
Top Products
[Note] Intercom numbers (Handset ID) are not stored in the last 10
numbers dialed log.
“BROADCAST” key
b. Hear bi-bi-beep while the initiating handset
broadcast all handsets within communication
coverage
c. Start to speak the message to be broadcasted
once you hear the “beep” sound; the
speakerphone of destination handsets will be
opened up
d. Press END key to end the broadcasting
Receiving a Telephone Call
~26~
1. When an incoming call arrives, the ringer will ring or vibrate unless the
ringer has been turned off.
2.
If the handset is on the charger cradle (ringer will be temporarily
switched to “Ring” if it has been set to “Vibrate”), lift the handset and
start conversation.
3. If the handset is not on the cradle, press any key (except END, and the
Silent soft key) to answer.
B. Broadcasting from Base to Handset
1. Broadcast to all handsets
a. Press Broadcast key on the base station to
intercom all registered handsets.
b. Hear bi-bi-beep while the initiating handset
broadcast all handsets within communication
coverage.
c. The Broadcast LED will light up
d. Press the Broadcast key again and return to
IDLE mode
11
PA paging from
Base 1
SLIENT
Notes:
1. You can press SILENT (Left) soft key if you choose to ignore
the call. Unlike turning off the ringer (from the handset menu),
the SILENT key operation is valid only for the current call.
2. If Caller ID service is available, the LCD will display the
incoming call information. If the LCD shows “Private” or
“Unknown”, the caller’s information may have been blocked by
the caller or the originating phone company.
C. Broadcasting from Handset to Base
1. Broadcast to the base station
a. Enter the Base ID and then press
“BROADCAST” key
b. Hear bi-bi-beep while the initiating handset
broadcast the base stations.
c. Start to speak the message to be broadcasted
once you hear the “beep” sound; the
speakerphone of the base will be opened up
d. Press the END key again and return to IDLE
mode
Receiving an Intercom Call
11
PA paging
to Ext. # 10
1. When an intercom call arrives, the ringer will ring or vibrate unless the
ringer has been turned off. Press TALK to answer the intercom call.
2.
If the handset is on the charger cradle (ringer will be temporarily
switched to “Ring” if it has been set to “Vibrate”), lift the handset and
start conversation.
3.
If the handset is not on the cradle, press any key (except PWR, END,
and the SILENT soft key) to answer.
Redial
1.
Press REDIAL (Left) soft key.
2.
The LCD shows the last phone number dialed. To dial this number,
press DIAL (Left) soft key.
3.
Use Up or Down Arrow Key to scroll through the last 10 phone numbers
dialed. Select and press DIAL key.
Notes:
1. The LCD displays the caller’s Handset ID.
2. You can press the SILENT if you choose to ignore the call. Unlike
turning off the ringer the SILENT key operation is valid only for the
current call.
~25~