Vertical Communications DX-80 Telephone User Manual


 
DX-80 Digital Executive Telephone User Guide Page 27
3. All digits dialed after this code will be sent in tone dialing format.
Release Key !52
You can use the Release Key to cancel or complete any current action. The
Release Key can speed call processing by allowing you to complete a call
transfer or end a call without hanging up the handset.
Saved Number Redial !51
Saved Number Redial is normally used whenever you want to retain a
telephone number to be dialed later. The same feature code is used to
save a number dialed (Save Dialed Number) and to dial the saved number
(Saved Number Redial). Once stored, the saved number will be recalled
when you dial the SNR code, regardless of what feature operations or
numbers have been dialed at your telephone since you stored the number.
Operation – SDN
1. After you place an outside line call, press !51.
2. The dialed number is stored in the Saved Number memory.
Operation – SNR
1. When the telephone is idle, press !51.
2. The stored number is dialed.
Transfer
Transfer is used to deliver calls from your extension to another extension.
Operation – Unsupervised
1. While connected to a call (outside line or intercom extension):
1.1. Press .
1.2. Dial the destination directory number where this call is to be
transferred (extension, UCD Group, Virtual Number, etc.)
OR…
1. If your phone has buttons that have been programmed to dial specific
extensions, press the appropriate button.
2. Hang up to complete the transfer.
Operation –Supervised
1. While connected to a call (outside line or intercom extension):