Vertical Communications DX-80 Telephone User Manual


 
Page 18 P7292 DETUG 09/01
Operation
1. When your telephone is set to Tone Ring and another station is calling
you, the display shows:
STA xx CALLING
2. Press !4. The display shows:
DO NOT DISTURB
3. The ring is discontinued and the call is sent to the programmed
attendant.
4. Your extension remains in Do Not Disturb until deactivated.
Forced Intercom Tone Ring *
When you initiate an intercom call, you can use Forced Intercom Tone
Ringing to cause the called telephone to ring. After a Voice Announce
connection has been established to an extension, you may change the alert
signal at that extension from Voice Announce to Tone Ring.
Operation
1. Establish an intercom call to an extension in Voice Announce mode
(Hands-free or Private). Your telephone will display:
VOICE CALL xx
msg
2. Press * to change the alert signal at the called extension from Voice
Announce to Tone Ringing. Your telephone will display:
CALLING STA 10
cbck msg
3. A Tone Ringing alert signal is sent and continues at the called
extension until it is answered.
4. If your call remains unanswered, you may dial * again to return to
Voice Call Announce mode.
Hold, Common (System) & I-Hold Indication
You may place any outside line on System Hold by pressing the
button. When you place a line on System Hold, the green lamp for that line
will flash at the I-Hold rate. I-Hold Indication allows you to distinguish easily
between a call you placed on hold at your telephone and calls placed on
hold at other telephones. The green lamp indicates that this is your holding