Filter
Top Products
Getting Started
Installing the Cisco SPA302D
Cisco SPA302D Mobility Enhanced Cordless Handset User Guide 11
1
STEP 7 Place the handset into the charging cradle. The light on the charging cradle
appears solid green when the handset is charging. Charge the handset for a
minimum of 10 hours before using the handset for the first time to ensure that the
handset is fully charged.
Registering the Handset to the Cisco SPA232D Mobility
Enhanced ATA
STEP 1 Install and configure the Cisco SPA232D. See the Cisco SPA232D Quick Start
Guide for more information.
STEP 2 On the Cisco SPA302 handset, press the Select button in the center of the 4-way
navigation keypad.
STEP 3 Using the navigation arrow buttons, scroll to the Settings icon and press the
center Select button to select it.
STEP 4 Select Handset Registration.
STEP 5 Select Register.
STEP 6 On the Cisco SPA232D, press the Page/Registration button and hold it down for
at least seven seconds until the green status light flashes quickly.
TIP If you press the button for fewer than seven seconds, the green status light flashes
slowly, indicating the unit is in “paging” mode and is not in registration mode.
Registration will not work if the unit is in paging mode.