Filter
Top Products
Getting Started
Installing the Cisco SPA302D
Cisco SPA302D Mobility Enhanced Cordless Handset User Guide 10
1
Charging the Handset
STEP 1 Remove the back cover of the handset.
STEP 2 Insert the two AAA rechargeable batteries (included) into the handset. Correct
battery placement is shown on the label inside the battery compartment. If the
batteries are charged, the handset turns on when the batteries are inserted. If the
batteries are not charged, the handset turns on when it is placed into the charging
cradle.
!
CAUTION Use only size AAA Ni-MH 800 mAh (1.2V) rechargeable batteries in the Cisco
SPA302D handset.
STEP 3 Remove the protective film from the handset and charging cradle.
STEP 4 Insert the power clip into the power adapter.
STEP 5 Insert the power adapter into the power source.
STEP 6 Connect the power adapter to the charging cradle in the port shown below.
!
CAUTION Only use the power adapter designed for use with Cisco SPA300 Series devices.