Filter
Top Products
5-60
Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator’s Guide for H.323 (version 3.0)
OL-4804-01
Chapter 5 Parameters and Defaults
Diagnostic Parameters
DialPlanEx
If your dial plan exceeds 199 characters, then use must use the DialPlanEx parameter to configure your
dial plans. The DialPlanEx parameter supports dial plans up to 499 characters in length. This range in
the number of characters is the only difference between the DialPlanEx and DialPlan parameters.
Therefore, all the information about the DialPlan parameter applies to the DialPlanEx parameter. For
more information, see the “DialPlan” section on page 5-52.
Note If you are not using this parameter for dial plan configuration, be sure this parameter is set to 0.
IPDialPlan
Description
This Iparameter allows for detection of IP-like destination address in DialPlan. Three values are valid:
• 0—String is dialed as is and not treated as an IP address.
• 1—When the Cisco ATA detects two asterisks (**), IPDialPlan takes over. The user enters the pound
(#) key to terminate the digit collection, and the interdigit timeout default is not used.
• 2—When IPDialPlan is set to 2, three asterisks (***) are required for IPDialPlan to take effect.
All other values are currently undefined.
Value Type
Integer
Range
0, 1 or 2
Default
1
Voice Configuration Menu Access Code
310
Diagnostic Parameters
This section describes the following parameters, which are used for diagnostic purposes:
• NPrintf, page 5-61
• SyslogIP, page 5-61
• SyslogCtrl, page 5-62