Filter
Top Products
5-27
Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator’s Guide for H.323 (version 3.0)
OL-4804-01
Chapter 5 Parameters and Defaults
Operational Parameters
CallFeatures
Description
Disable/enable CallFeatures by setting each corresponding bit to 0 or 1.
The lower 16 bits are for the Phone 1 port, and the upper 16 bits are for the Phone 2 port. Table 5-2
provides definitions of each bit.
Note The subscribed features that can be permanently disabled by the user are CLIP_CLIR, call waiting and
Fax mode. A subscribed service enable/disabled by the user can be disabled/enabled dynamically on a
per-call basis.
Value Type
Bitmap
Default
0xffffffff
Voice Configuration Menu Access Code
314
Related Parameters
• PaidFeatures, page 5-28
• CallCmd, page 5-29
• CallerIdMethod, page 5-38
Table 5-2 CallFeatures Parameter Bit Definitions
Bit
Number Definition
0 and 16 Not used for H.323.
1 and 17 Not used for H.323.
2 and 18 Not used for H.323.
3 and 19 Caller Line Identification Restriction (CLIR)—0; Caller Line Identification Presentation (CLIP)—1
4 and 20 Call waiting
5 and 21 Three-way calling
6 and 22 Not used for H.323.
7 and 23 Not used for H.323.
8 and 24 Caller ID. This service enables the Cisco ATA 186 to generate a Caller ID signal to drive a Caller ID display
device attached to the FXS line.
9 and 25 Not used for H.323.
10 and 26 Not used for H.323.
11 and 27 Call Waiting Caller ID. This is available only if the Method bit in CallerIdMethod is set to Bellcore (FSK).