Filter
Top Products
5-29
Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator’s Guide for H.323 (version 3.0)
OL-4804-01
Chapter 5 Parameters and Defaults
Operational Parameters
CallCmd
Description
Command table that controls call commands such as turning on/off caller ID.
For detailed information on the CallCmd parameter, see Chapter 6, “Call Commands.”
Value Type
Alphanumeric string
Range
Maximum of 248 characters
Default
U.S. Call Command Default
Af;AH;BS;NA;CS;NA;Df;EB;Ff;EP;Kf;EFh;HH;Jf;AFh;HQ;I*67;gA*82;fA#90v#;OI;H#72v#;bA#74
v#;cA#75v#;dA#73;eA*67;gA*82;fA*70;iA*69;DA*99;xA;Uh;GQ;
Voice Configuration Menu Access Code
930
Related Parameters
• CallFeatures, page 5-27
• PaidFeatures, page 5-28
• CallerIdMethod, page 5-38
• SigTimer, page 5-31
6 and 22 Not used for H.323.
7 and 23 Not used for H.323.
8 and 24 Caller ID. This service enables the Cisco ATA 186 to generate a Caller ID signal to drive a Caller ID display
device attached to the FXS line.
9 and 25 Not used for H.323.
10 and 26 Not used for H.323.
11 and 27 Call Waiting Caller ID.
12-14 and
28-30
Reserved.
15 and 31 Fax mode. This service allows the user to set the Cisco ATA to Fax mode on a per-call basis. For Fax mode, use
the following settings:
• G711 codec only
• No silence suppression
• No FAX tone detection
Table 5-3 PaidFeatures Parameter Bit Definitions (continued)
Bit Number Definition