Filter
Top Products
5-34
Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator’s Guide for H.323 (version 3.0)
OL-4804-01
Chapter 5 Parameters and Defaults
Operational Parameters
OpFlags
Description
This parameter enables/disables various operational features.
See Table 5-6 on page 5-35 for bit definitions of this parameter.
Value Type
Bitmap
Default
0x2
Voice Configuration Menu Access Code
323
Related Parameters
• TftpURL, page 5-5
• DHCP, page 5-8
• VLANSetting, page 5-12
16 0/1—Disable check-bearer capability in the received Q.931 Setup message.
If this setting is enabled, the Cisco ATA returns the value 65 as the release-complete cause if the
Information Transfer Capability (ITC) is “unrestricted digital information” or “restricted digital
information.” The Cisco ATA returns the value 100 as the release-complete cause if the ITC is
“unrestricted digital information with tones/announcements” or "video."
Default: 0
17—18 Not used for H.323.
19 0—Disable sending ringback tone to the caller.
1—Enable sending ringback tone to the caller.
Default: 0
20-22 Not used by H.323.
23 0/1—Disable/enable user-configurable setting for call-waiting default.
If this value is 0 (default), the end user cannot configure the permanent default call-waiting setting for
every call. Instead, the service provider's default call-waiting setting is used for every call.
If this value is 1, the end-user can configure the permanent default call-waiting setting for every call, thus
overriding the value set by the service provider.
Default: 0
24 0/1—Disable/enable the mixing of audio and call waiting tone during a call.
Default: 0
25 to 31 Reserved.
Table 5-5 ConnectMode Parameter Bit Definitions (continued)
Bit Number Definition