Filter
Top Products
6 OL-22334-01
Adjusting the Handset Rest
When you connect your phone, you may want to adjust the handset rest to ensure that the receiver will
not slip out of the cradle. See the table below for instructions.
Registering with TAPS
After your phone is connected to the network, your system administrator may ask you to auto-register
your phone using TAPS (Tool for Auto-Registered Phones Support). TAPS can be used either for a new
phone or to replace an existing phone.
To register with TAPS, pick up the handset, enter the TAPS extension provided by your system
administrator, and follow the voice prompts. You may need to enter your entire extension, including
the area code. After your phone displays a confirmation message, hang up. The phone will re-start.
1
DC Adaptor port (DC48V) (optional)
2
Network port (10/100 SW)
3
Access port (10/100 PC)
4
Headset port
5
Handset port
1
Set the handset aside and pull the square plastic tab from the handset rest.
2
Rotate the tab 180 degrees.
3
Slide the tab back into the handset rest. An extension protrudes from the top of the rotated tab.
Return the handset to the handset rest.
1 2 3
77354