Filter
Top Products
Advanced Call Handling
Cisco Unified IP Phone 7905G and 7912G for Cisco Unified CallManager 5.0 (SCCP) 31
Storing and Retrieving Parked Calls
You can “park” a call when you want to store the call so that you or someone else can retrieve it from
another phone in the Cisco Unified CallManager system (for example, at a co-worker’s desk or in a
conference room).
Call Park is a special feature that your system administrator might configure for you.
Note You have a limited amount of time to retrieve the parked call before it reverts to ringing at its
original destination. See your system administrator for this time limit.
Use Abbreviated Dialing 1. Set up Abbreviated Dialing codes. See the “Setting Up Speed Dials
on the Web” section on page 48.
2. To place a call, enter the Abbreviated Dialing code and press
AbbrDial.
Use Fast Dial 1. Create a Personal Address Book entry and assign a Fast Dial code.
See the “Using Personal Directory on the Web” section on page 46.
2. To place a call, access the Fast Dial service on your phone. See the
“Using Personal Directory on Your Phone” section on page 42.
If you want to... Then...
Store an active call using
Call Park
During a call, select more > Park. The phone screen displays the special
call park number at which the call is stored. Make a note of the call
park number and hang up.
Retrieve a parked call Enter the call park number from any Cisco Unified IP Phone in your
network to connect to the call.
If you want to... Then...