Filter
Top Products
Installing Your Phone
Connecting Your Phone to the Network
Cisco Small Business Pro IP Phone SPA 50X User Guide (SIP) 20
2
Connecting Your Phone to the Network
If you are using an Ethernet connection:
STEP 1 Insert one end of the Ethernet cable into the network port on the phone body
marked “SW.”
STEP 2 Insert the other end of the Ethernet cable into the appropriate device, such as a
network switch, on your network.
Connecting the Phone to the Wireless Network
You can use the Cisco WBP54G Wireless-G Bridge for Phone Adapters to connect
the IP phone to a Wireless-G network instead of the wired local network.
NOTE This procedure requires the optional Cisco SPA 9000 Voice System IP Phone
PA100 power adapter to provide power to the WBP54G.
To connect your phone to the Cisco WBP54G:
STEP 1 Configure the Cisco WBP54G using the Setup Wizard. See the instructions in the
Wireless-G Bridge for Phone Adapters Quick Installation Guide
, available on
cisco.com. See Appendix A, “Where to Go From Here,” for a list of documents
and locations.
STEP 2 During the Setup Wizard process, connect the Ethernet network cable of the
WBP54G to the back of the IP phone base station into the slot marked “SW.” See
the “Phone Connections” graphic.
STEP 3 Connect the power cable of the WBP54G to the power port on the IP phone base.
STEP 4 Plug the IP phone power adapter into the power port of the WBP54G.
STEP 5 Plug the other end of the IP phone power adapter into an electrical outlet.