Filter
Top Products
TS-100 Owner’s Manual
REDIAL BUTTON
1. If the number you dialed is busy, or you want to call the last number dialed again, lift
the handset, or press and release the hookswitch for a new dial tone.
2. Press REDIAL. The number will appear on the display window.
3. The last number called (31 digits maximum) will automatically be redialed.
Note: If you use a hunt group such as ‘9’ to get external dialtone first, you
may encounter problems with dialing out since it takes time for
TalkSwitch to switch from internal dialtone to external dialtone so
the 1st digit of the phone number may be missed by the phone
company.
PAUSE BUTTON
The PAUSE button allows you to insert a 3.6-second pause in the dialing sequence. This
is particularly useful if you are connected to a PABX system where you must dial an
access code (usually the number 9) to obtain an outside line.
1. Press the PAUSE button once and release at any point in the dialing sequence where
a pause is desired.
2. The PAUSE button can be pressed more than once to create a longer pause.
HOLD BUTTON
1. To place a call on hold using TalkSwitch, be sure to use the HOLD/FLASH button
located at the top right NOT the HOLD button located at the bottom left. The HOLD
button located at the bottom of the phone should only be used when the phone is not
connected to a phone system.
2. To retrieve a caller simply press HOLD/FLASH + ‘7’. If you hung up the phone after
putting a call on hold, the phone will ring back within 60 seconds. Answer the phone
and you will be connected to the caller.
HOLD/FLASH BUTTON
This telephone provides a line break signal for putting callers on hold or to transfer calls.
1. To place a call on hold using TalkSwitch, be sure to use the HOLD/FLASH button
located at the top right not the HOLD button located at the bottom left. The HOLD
button located at the bottom of the phone should only be used when the phone is not
connected to a phone system.
2. To retrieve a caller simply press HOLD/FLASH + ‘7’. If you hung up the phone after
putting a call on hold, the phone will ring back within 60 seconds. Answer the phone
and you will be connected to the caller.
Flash can also be used when storing numbers in memory locations when Direct Line
Access has been enabled on Local Extensions connected to TalkSwitch.
Telephone Features
6