Filter
Top Products
Freelance 3000 user guide ~ 2nd Edition ~ 11th October ’04 ~ 6397
36
To switch the answering
machine ON/OFF
Your BT Freelance XA 3000 is
set to ON and Answer and
Record when first powered up.
Press and release the
ANSWER ON/OFF button to
switch ON or OFF.
If you hear “Answer on, your
outgoing message is....” the
answering machine is switched
on and is ready to answer
incoming calls and record any
messages, unless Answer Only
is selected.
Answer Only is an advisory
announcement only, so that the
machine will not record an
incoming message.
See page 38 for a full
explanation of the outgoing
messages available.
The display on the base unit
shows the number of messages
stored in the memory.
If you hear “Answer off”
the answering machine is
switched off.
The display on the base unit
will flash between a dash and
the number of messages
saved in the memory.
To adjust the base unit
loudspeaker volume
The loudspeaker volume
ranges from 0-9 plus H, where
0 is Off and H is the
maximum level. The default
level is 5.
Press Vol + on the base to
increase the volume.
Press Vol – on the base to
decrease the volume.
If you adjust the volume when
the answering machine is not
being used, a beep sounds at
each press. When the volume
reaches its highest or lowest
levels two beeps will sound.
Answer delay
Answer delay sets the number of
times your BT Freelance XA 3000 will
ring before the answer machine picks
up your call and starts playing the
outgoing message. The default setting
is for the answering machine to
answer after 6 rings. You can change
this setting to between 2-9 rings.
Ans.
On/Off
ANSWER MACHINE