Filter
Top Products
53
BT Studio 3500 – Issue 1 – Edition 2.1 –02.04.07 – 7999
If you experience any problems, please call the Helpline on 0870 605 8047 or email bt.helpdesk@suncorptech.com
General information
Product disposal instructions
The symbol shown here and on the product
means that the product is classed as Electrical
or Electronic Equipment and should not be
disposed with other household or commercial waste
at the end of its working life.
The Waste of Electrical and Electronic Equipment
(WEEE) Directive (2002/96/EC) has been put in place
to recycle products using best available recovery and
recycling techniques to minimise the impact on the
environment, treat any hazardous substances and
avoid the increasing landfill.
Product disposal instructions for residential users
When you have no further use for it, please remove
any batteries and dispose of them and the product as
per your local authority’s recycling processes. For
more information please contact your local authority
or the retailer where the product was purchased.
Product disposal instructions for business users
Business users should contact their suppliers and
check the terms and conditions of the purchase
contract and ensure that this product is not mixed
with other commercial waste for disposal.
Connecting to a switchboard
This telephone may be connected to most types of
switchboard, however in the event of any difficulties,
consult your switchboard Service Provider.
Dialling mode
Your BT Studio 3500 is set to Tone dialling. Some
older switchboards may require Pulse dialling.
To change the dialling mode, see Dial Mode, page 45.
Flash duration
Your BT Studio is set to a Flash duration of 100ms.
You cannot change the setting.
Access code and entering a pause
Some internal switchboards may require you to enter
an access code (e.g. 9) to get an outside line. So that
the switchboard has time to pick up an outside line
before the rest of the number is dialled, you may
need to add a pause in the dialling sequence. For
example: 9 P 0870 605 8047.
1. After the access code, press to insert a pause
before entering the telephone number. The display
shows P.
8474 Studio 3500 UG Iss2 [2] 25/10/07 16:37 Page 53