Filter
Top Products
Record your own OGM
This will replace the pre-recorded or your own previous
outgoing message. However, you can re-instate the
pre-recorded OGM at any time by deleting your own
recorded OGM.
Using the base:
1. Press and hold until prompted to select which type of
OGM you want to record.
2. Press and keep holding to select Answer & Record
or to select Answer Only. The machine announces
“Please speak after the tone to end recording release the
button”, then a beep is heard.
3. Whilst still holding or , speak your message slowly
and clearly, close to the base.
4. To end recording, release the or button.
Using the handset:
1. Press , scroll to
TAM SETTINGS
and press .
2. Scroll to
OGM SETTING
and press .
3. Scroll to
RECORD OGM
and press .
4. Press or to select either
ANS AND REC
or
ANS ONLY
and
press .
31Using the answering machine
BT Studio 3500 – Issue 1 – Edition 2.1 –02.04.07 – 7999
If you experience any problems, please call the Helpline on 0870 605 8047 or email bt.helpdesk@suncorptech.com
Answer Only
With Answer Only selected, your
caller will hear an announcement only
and will not be able to leave
a message. The pre-set Answer Only
outgoing message is “Hello, your call
cannot be taken at the moment and
you cannot leave a message, so
please call later”.
If recording your own Answer Only
message, remember to advise your
caller that they will not be able to
leave a message.
To reinstate either pre-recorded
message, delete your own message.
8474 Studio 3500 UG Iss2 [2] 25/10/07 16:37 Page 31