Filter
Top Products
PARTNER
®
Advanced Communications System
37
PARTNER
®
ACS 1600 DSL Module Planning Checklist
Required Information Notes Sample values Enter values for current installation
Transmit/Receive CIR
1
The Committed Information Rate (CIR) to and from the provider. Default values may be
used unless instructed by provider. Value should be the same for both voice and data
PVCs.
There are three values associated with CIR:
• Committed Burst Size (Bc)
• Circuit throughput
• Excess Burst Size (Be)
Leave each of these settings at default values unless instructed otherwise by the service
provider.
FRF.12 End-to-End
Fragmentation
1
Leave this setting at the default value unless instructed
otherwise by the service provider.
Enabled or Disabled Voice:
Data:
Fragment Size
1
Leave this setting at the default value unless instructed
otherwise by the service provider.
100-1600 Voice:
Data:
4. ATM PVC Settings Obtain these permanent virtual circuit settings if your SDSL provider uses the ATM protocol. Remember that separate PVC settings
are required for the voice and data connections.
VPI
1
Unique Virtual Port Identifier value assigned to each
ATM connection
32, 33 Voice:
Data:
VCI
1
Unique Virtual Circuit Identifier value assigned to each
ATM connection.
34, 35 Voice:
Data:
Encapsulation
1
The manner in which headers are assigned to packets.
Differentiates between voice calls and data. This does
not default automatically. It must be set manually.
Proprietary Voice,
RFC 1483
Voice: Proprietary Voice
Data: RFC 1483
Service Category
1
The manner in which bits are handled in the PVC.
Differentiates between voice calls and data. Defaults
automatically to UBR for PVCs using proprietary voice
encapsulation.
CBR, UBR Voice: CBR
Data: UBR
1. Obtained from SDSL provider
2. Obtained from ISP
3. Obtained from customer/LAN VAR