Filter
Top Products
Interface Control
Issue 2.2 April 2005 45
Interface Control
Use the following procedure to set or change the interface control value.
Note:
Note: The 4601, 4602, and 4690 Telephones do not have Ethernet PC interfaces, so
this procedure does not apply to those phones.
1. While the phone is on-hook and idle, press the following sequence of keys on the faceplate
of the telephone:
Mute 4 6 8 # (Mute I N T #)
Note:
Note: Press the Mute button momentarily. Do not press this button while pressing other
keys/buttons. The 4630 and 4630SW IP Telephones do not have a dedicated
Hold button. For all other 4600 Series IP Telephones, pressing the Hold button
instead of the Mute button also works.
2. For telephones that support an Infrared (IR) interface (4620 and 4620SW only), proceed
directly to Step 7. If the telephones have an internal Ethernet switch, proceed to Step 3.
After entry of the command sequence, telephones with an internal Ethernet switch display
the following text, depending on the current interface control value:
where status is the value of PHY1STAT, defined as:
● Status is auto when PHY1STAT = 1
● Status is 10Mbps HDX when PHY1STAT = 2
● Status is 10Mbps FDX when PHY1STAT = 3
● Status is 100Mbps HDX when PHY1STAT = 4
● Status is 100Mbps FDX when PHY1STAT = 5
PHY1=status
*=change #=OK