Filter
Top Products
4600 Series IP Telephone LAN Administrator’s Guide
Hardware Requirements
3-2
■ The following two circuit packs must be resident on the PBX server used to support the IP
telephones:
— TN2302 AP Media Processor circuit pack converts the audio levels for the IP telephone to
audio levels for DCP phones when IP phones are used in a call with non-IP telephones.
— TN799 Control-LAN (CLAN) circuit pack for the signaling capability (either the B or C
vintage) on the csi, si, and r platforms.
■ A Category 5 LAN. If the telephones are to be powered from the LAN, the LAN must comply
with the IEEE 802.3af standard for LAN powering.
■ Electrical power provided to each phone by one of the following two sources.
— A Telephone Power Module (DC power jack) (must be ordered separately).
— IEEE 802.3af, if the LAN supports this powering scheme (although the 4630 cannot be
powered this way).
■ Verify that the 4600 Series IP Telephone package includes the following components:
— 1 telephone set.
— 1 AB1C handset.
— 1 H4DU 9-foot long (when extended) 4-conductor coiled handset cord, plugged into the
telephone and the handset.
— 1 Category 5 modular line cord for the connection between the IP Telephone and the
Ethernet wall plug.
— Non-system-specific safety and installation documentation.
— Power brick
— Stylus (4630 IP Telephones only)
■ You may need a Category 5 modular line cord for the connection from the 4600 Series IP
Telephone to the PC.
Refer to the 4600 Series IP Telephone Installation Guide.
The IP telephones work the same on all DEFINITY
®
/MultiVantage
TM
platforms.
For Release 1.1 of any of the 4600 Series IP Telephones, the DEFINITY
®
switch must
have Release 9 software installed. For Release 1.5 of any of the 4600 Series
Telephones, the DEFINITY
®
switch must have Release 9.5 software. For Release 1.6 of
the 4600 Series IP Telephones, and for support of the 4630 IP Telephone, the
DEFINITY
®
switch must have Release 10 software. For Release 1.7 of the 4600 Series
IP Telephones, and for support of the 4602 and 4620 IP Telephones, the MultiVantage
TM
switch must have Release 11 software.