Filter
Top Products
Phone Controls Page 18
Phone Controls
Labeling Softkey Functions
You can rename the softkey functions that appear when you press Menu
. Note that this doesn't affect the function names shown when you
select Prog or Admin.
4406D+, 4606D+ and TransTalk
®
MDW 9040 users do not have access to
this feature.
To relabel softkey functions
:
1. Press Menu
.
2. Using the
and keys, display and then select Prog (This feature can
also be set under a DSS key, see page 22).
3. Use the
and keys to display and select the function to relabel.
4. Press Label.
5. Use the dialing keys and Rotat to enter characters, e.g. to enter an L
press the 5 key and then press Rotat until an L is displayed.
6. When the label is as you require press Done.
Display the Date and Time
You can change your phone display to show the date and time. This uses
the TmDay function. Note that this function overwrites all other display
information.
TransTalk
®
MDW 9040 users do not have access to this feature.
To set/cancel date and time display
:
1. Press Menu .
2. Using the
and keys, display and select TmDay (This feature can
also be set under a DSS key, see page 22).
Call Timer
You can run a call timer. If you start the timer before making a call, it will
reset to zero when you dial and again when you are connected.
Note that after ending a caller the timer is switched off.
TransTalk
®
MDW 9040 users do not have access to this feature.
To start the call timer
:
1. Press Menu
.
2. Select Timer (This feature can also be set under a DSS key, see page
22).
4400, 4600, 6400 & TransTalk MDW 9040 Telephones Page 18
IP Office 40DHB0002USAL - Issue 6 (04/25/2003)