Filter
Top Products
Outgoing messages
15
Recording an outgoing message
Select the desired OGM using the
selection button next to the OGM
symbol.
The selected OGM is displayed next to
the symbol on the bottom right of the
display.
Press and hold OGM.
Wait, you will hear a short tone, a micro-
phone is displayed to signal ongoing in-
coming message.
Start speaking (maintain approx. 5
cm distance from the microphone).
The display shows the time that you
have been speaking.
Release OGM to interrupt recording.
"With incoming message" and "Without
incoming message" is displayed.
To continue the recording press
and hold OGM again.
The recording continues.
To cancel the recording press stop. The recording is cancelled.
Using the selection button next to
the relevant line select whether the
OGM should provide the option of
leaving an incoming message or
not.
The OGM is completed and is played
back for verification purposes. If the
OGM gives the option of recording and
ICM you will hear a beep at the end. If
the OGM does not give the option of re-
cording you will hear two beeps at the
end.
If you record OGM 5 without the option to record (OGM only) when the in-
coming message capacity is full your Voicemail Center 461.2 switches to
this OGM automatically.