Filter
Top Products
6
Getting started
Telephone base installation
NOTES:
1. Use only the power adapter supplied with this product or equivalent. To order a replace-
ment power adapter, visit our website at www.telephones.att.
com, or call 1 (800) 222-3111. In Canada dial 1 (866) 288-4268.
2. Be sure to use an electrical outlet not controlled by a wall switch.
3. This power adapter is intended to be correctly oriented in a vertical or floor mount position.
4. If you receive high speed internet through your telephone line (commonly referred to as DSL), and
you are experiencing interference during telephone conversations and/or your caller ID features
are not functioning properly, install a DSL filter to the telephone line between the telephone base
and the telephone wall jack. Contact your DSL service provider for a DSL filter.
Telephone line cord
DSL filter
(Optional for DSL users, see number
four in the note section, below.)
5. Plug the other end
of the telephone line
cord into a telephone
jack.
4. Plug the large end of
the larger power adapter
into an electrical outlet
not controlled by a wall
switch.
3. Route cords through
slots.
2. Plug one end of the
telephone line cord into
the telephone jack at the
bottom of the telephone
base.
1. Plug the small end of the larg-
er power adapter into the power
jack at the bottom of the tele-
phone base.
6. Plug one end of the coiled handset cord into the jack at
the bottom of the telephone base. Plug the other end of the
coiled cord into the base handset.