Filter
Top Products
38
Answering system operation
Day & time announcements
To set day and time
Before playing each message, the answering sys-
tem announces the day and time the message
was received.
Before using the answering system, follow the
steps on the left to set the day and time so mes-
sages are dated correctly. If the clock is not set
before playing messages, the system will prompt
"Time and date not set" each time.
The system uses voice prompts to guide you.
Each time you press SKIP or REPEAT, the
day, hour, minute or year increases or decreases
by one. When you hear the correct setting, press
CLOCK to move to the next setting.
To check day and time
You can press CLOCK at any time to hear the cur-
rent day and time without changing it.
1.
Press CLOCK
The system will announce
the current clock setting,
then announces "To set the
clock, press CLOCK."
2.
Press CLOCK
3.
Press SKIP
or REPEAT
4.
until the system announces
the correct hour, then press
CLOCK.
until the system announces
the correct minutes, then
press CLOCK.
until the system announces
the correct day, then press
CLOCK.
5.
6.
until the system announc-
es the correct year, then
press CLOCK. The system
announces the current clock
setting.
The system will announce
the current day setting,
then announces "To change
the day, press SKIP or
REPEAT, to change the
hour, press CLOCK."
16
Press SKIP
or REPEAT
Press SKIP
or REPEAT
Press SKIP
or REPEAT
NOTES:
1. You can
press and hold SKIP or REPEAT to increase
or decrease the minute or year by ten.
2. Caller ID provides the time and date. Set the year so that
the day of the week can be calculated from the caller ID
information. After you set the time once, it will always be set
automatically with incoming caller ID information. The time
will be set automatically only if you subscribe to caller ID
service provided by your local telephone company (page 29).