Filter
Top Products
Speaker
Note: Your voice terminal is set for either the Speaker (listen-only) or the
Speakerphone (listen and talk) function. Check with your System Manager to see
which of these two features you can use.
You can use the Reset Speakerphone feature only if your voice terminal is set for
Speakerphone (listen and talk).
Use the following procedures if your voice terminal is set for the Speaker (listen-
only) feature.
To place a call without
lifting the handset, or to
use speaker with any
listening-only feature
activity (such as,
monitoring a call on
which you have been put
on hold or for group
listening)
Note: In order for the
other party to hear you,
you must speak through
the handset.
1
2
3
Press [
Speaker Reset Spkr
]
Green light next to [
Speaker Reset Spkr
] goes on; red light
next to [ Mute ] goes on
Place call or access selected feature
Adjust speaker volume if necessary
To raise the volume, press the right half of the
Speaker Volume control button labeled [
∧ ] ;
to lower the volume, press the left half of the
Speaker Volume control button labeled [
∨ ]
If you have a display, it shows
[
SPEAKER L > > > > H ]
●
●
●
(There are 8 possible volume settings. On the
display, 1 arrow is the lowest setting, and 8
arrows is the highest setting)
To mute the microphone
Press [
Mute ]
associated with the
handset so the other
Red light goes on and other party cannot hear
party cannot hear you
you
Press [ Mute ] again to resume talking to other party
through handset
To activate the speaker
Press [
Speaker Reset Spkr
]
while using the handset
Green light next to [
Speaker ] and the red light
next to [
Mute ] go on steadily
1
2
1
●
●
●
●
Red light goes off and other party can hear you
again
The speaker is active, and the handset is turned
off
25