Filter
Top Products
AltiTouch 500 Manual 7
7. The display indicates the “OUTSIDE
ACCESS?”prompt.
a. If you don't need to dial a number to
access an outside line, press the Dial/
Enter buttonandgotoStep 8.
b. Alternatively, enter the trunk access
code (up to 4 digits), press the Dial/
Enter buttonandgotoStep 8.
c. If you enter a trunk access code by
mistake, press the Delete button or
the "button to delete the digits.
The trunk access code will be automatically dialed prior to any number
over 6 digits stored in the caller ID memory only.
Note: Numbers stored in the directory or as programmable keys
will not have the trunk access code automatically dialed —
you will need to include the trunk access code as part of the
dialing stream when storing numbers to the directory or
programmable keys.
A stored number with 6 or fewer digits is considered an internal
extension number. A PAUSE period or 3 seconds delay is inserted
automatically between the trunk access code and the phone number.
8. Press the Menu or Save button to save these operating settings and to
exit the menu mode.
9. After installation, lift the telephone's Handset and listen for the dial
tone. If there is no dial tone, check to make sure all cords are firmly
plugged into their jacks.
Note: Programming your area code will allow you to easily dial numbers
that are in your Caller ID list. See the Section “Calling Back a
Number from the Caller ID List” for more information on dialing
calls from your Caller ID list.
Wall Mounting
1. Turn the phone over so that you are looking at the bottom of the phone.
Insert tabs at the thin end of the wall mount bracket into the holes at
the rear of the phone bottom. Press and latch the tabs at the thicker end
of the wall bracket into holes at the front end of phone. The back of the