Filter
Top Products
Alti-IP 600H Manual 26
Disabling DHCP
If you do not use DHCP in your network, you can disable DHCP before
manually assigning an IP address to the Alti-IP 600H. To disable DHCP,
use the following steps:.
Note: Procedures involving configuring IP settings cannot be completed
when DHCP is enabled in your network.
1. Press * * 7 + ENTER button.
2. Use / to select Network, then press the Enter key.
3. Scroll to Enable DHCP.
If DHCP is enabled, the option displays as DHCP Enabled YES.
4. Press (DOWN key) to disable DHCP.
Configuring IP Settings
Use these guidelines when manually configuring the IP settings:
• Ensure the default gateway IP address in on the same subnet as the host
IP address.
• When inputting IP addresses into the Alti-IP 600H, use the * key to
enter periods. For example, “209.120.12.8” would be inputted as
“209*120*12*8”.
Assigning a Local IP Address
The IP address is the unique logical address identifying each host computer
on a TCP/IP network. An IP address is a 32-bit number expresses as four
decimal numbers from 0 to 255 separated by periods.
To assign an IP address, use the following steps:
1. Press * * 7 + ENTER button.
2. Use / to select Network, then press the ENTER button.
3. Scroll to Local Address.
4. Press the ENTER button or(FORWARD key).
5. Use the buttons on the dial pad to enter a new IP address, using the *
key to enter periods. Use the (BACK key) to correct any mistakes.
6. Press the ENTER button.