Filter
Top Products
Alti-IP 600H Manual 8
AltiGen IP Phone Service
AltiGen IP Phone Service is installed together with AltiServ, runs on the
same system as AltiServ, and connects to AltiServ through enhanced
AltiLink+ protocol on behalf of Alti-IP 600H phones. This service must be
running for the Alti-IP 600H to operate. If IP Phone Service stops while the
Alti-IP 600H is on a call, the call will be disconnected.
Plug and Play Feature
The Alti-IP 600H supports a plug and play feature when running AltiWare.
When the phone is first booted up, this feature will enable the phone to
automatically register itself to AltiServ, instead of having to program the
phone manually. Refer to “Configuring Startup Network Settings” on page
14 for requirements and setup.
Note: The Plug and Play feature requires AltiGateKeeper Discovery and
a single gatekeeper on the LAN.
Basic Mode
The Alti-IP 600H operates in Basic mode if it fails to register with AltiWare
during the startup mode. When in basic mode, the IP Phone’s LCD display
shows “(BASIC) IDLE”. No AltiWare switching features are available
in this operating mode. However, the phone user can enter a destination IP
address followed by #, and make an outgoing call through the IP network
to reach AltiWare or another Alti-IP 600H phone. Also, the IP phone can
accept incoming calls originating from AltiWare or another Alti-IP 600H
phone.
Normal Operation
In normal operating mode, the Alti-IP 600H should have been registered
with the phone server and logged in as an extension. The time and
extension appear in the LCD screen and all phone features are enabled.
Note: To make the Alti-IP 600H work in normal operating mode, open
the firewall port 10032 for the phone server. Refer to the AltiWare
OE/ACC System Installation & Administration Manual or ACM
System Administration Manual for information on other firewall
ports for H.323.