Filter
Top Products
Alti-IP 600H Manual 16
Plug and Play Setup
The steps for plug and play setup will vary depending on whether or not the
Alti-IP 600H Phone has been started. When the Alti-IP 600H is started for
the first time, it can support plug and play to enable the phone to
automatically register itself to AltiServ. If the Alti-IP 600H has already
been started, follow the instructions “Plug and Play Setup After IP Phone
is Started” on page 17.
Important Notes:
• To use the Plug and Play feature, the user’s IP Phone must be on the
local LAN with AltiServ
• There can only be one (1) AltiServ on the LAN.
• Gatekeeper auto discovery uses broadcast UDP packets which work in
the LAN or VPN environment, but not through the public IP network.
Plug and Play Setup Before IP Phone is Started
To set up your IP Phone to properly execute the Plug and Play feature,
perform the following steps BEFORE YOU START THE PHONE:
1. Ensure the AltiGen GateKeeper is running and configured to point to
the AltiWare system.
2. Ensure DHCP server is up and running.
3. Ensure that there are enough IP addresses.
4. Ensure that there is an available virtual extension with the IP extension
feature enabled and dynamic IP address is selected.
5. Power up the IP Phone.
6. Enter the extension number and password.
7. The phone will attempt to register as shown in the LCD screen.