Filter
Top Products
35
GETTING STARTED USING THE SYSTEM APPENDIX
SETTING AND ADJUSTMENT
Calling another station (direct voice call)
Follow the steps below to call a desired door station, room sub
station, master station in your site, or a remote site.
Search for and select the station or remote site you
1
want to call (so that it is highlighted) in one of the
search methods. (→P. 28-34)
If you call (the pilot station in) a remote site by searching
*
for it from [REMOTE SITE] of SEARCH LIST, select
the target site, and then select [CALL] (so that it is
highlighted). (→P. 32)
Refer to the on-screen instructions:
Be sure to make operations by checking the information on the
upper part of the monitor. The next operations you can perform
are displayed.
e.g.)
[
] TALK … You can start talking by pressing
TALK
or
lifting the handset.
* If you will not set the priority, it is set to
“Normal”.
[
] MONI …
You can start monitoring by pressing
MONITOR
.
[ ] PR (or PRIORITY)
……… You can proceed to the priority setting
mode by pressing
ZOOM/WIDE
.
To set the priority, press
2
ZOOM/WIDE
, and then
press to select the target priority (so that it is
highlighted).
If you wi
*
ll not set the priority, skip this step and press
TALK
or lift the handset. You can start calling (talking).
Press
3
TALK
or
ZOOM/WIDE
or lift the handset to
start calling (talking).
When a tone rings, your voice is heard at the target station
and you can also hear sounds at the target station. (Direct
voice call)
The receiver can answer the call without pressing any
button or lifting the handset. (Talk back)
If the target station is a master station, the response of
*
it differs from the PRIVACY MODE setting on the target
station. (See the table below.)
PRIVACY MODE
setting on the target
master station
Response
OFF
Your voice is heard at the target
station and you can also hear sounds
at the target station.
1
Communication is enabled when the
receiver presses
TALK
or lifts the
handset. Otherwise you can hear no
sound from the target station.
2
When the target station receives your
call, a tone notifi es you that the target
station is in the (PRIVACY MODE) 2.
Communication is enabled when the
receiver presses
TALK
or lifts the
handset. Otherwise you can hear no
sound from the target station.
* You can adjust the volume of call
tone from [RECEIVE VOL] by
pressing
SETTING
.
Press
4
OFF
or hang up the handset to fi nish
communicating.
or
or