Filter
Top Products
23
GETTING STARTED USING THE SYSTEM APPENDIX
SETTING AND ADJUSTMENT
■
Communication by using the handset
<In the hands-free mode>
Lift the handset and you can communicate with the
1)
handset.
* You can also communicate in the press-to-talk
mode by pressing and holding
TALK
.
When you have fi nished the communication, put the
2)
handset on the hook.
Communication will end.
<In the press-to-talk mode>
You can communicate in the press-to-talk mode by
pressing and holding
TALK
even when you are
communicating with the handset.
NOTE:
Communication will end automatically according to the set
communication time.
When two or more calls have arrived (IS-MV)
An IS-IPMV cannot receive two or more calls at a time.
*
Select a call to answer by following the steps 1) and 2)
1
below.
Press
1)
LIST
.
The list of calling sub stations is displayed.
Press
2)
repeatedly so that the station no. (and/or
name) of the sub station you will select is highlighted.
* Calls from other master stations are not displayed
in the list.
Press
2
TALK
,
ZOOM/WIDE
or lift the handset
*1
, and
you can answer the call.
When the communication is fi nished, subsequent
*
incoming calls ring.
(When you are receiving calls from sub stations):
*
If you select another sub station while communicating,
the current communication is forcibly stopped, and then
you can answer the selected station with direct voice call
after a beep.
*
1
: When you are receiving a direct voice call from another
master station, lifting the handset will not enable you
to communicate with the selected sub station. In that
case, press
TALK
or
ZOOM/WIDE
with the handset
lifted.
About the priority
The order of priority for two or more actions (communication,
calling, paging, monitoring, etc.) performed at the same time
is as follows depending on the priority setting.
Priority Setting Action
1 (high) [URGENT], [BROADCAST]*
2
Communication,
calling, paging,
chime paging.
2 [PRIORITY]
3 [NORMAL]
4 (low) - Monitoring, scan-
monitoring
Earlier call has priority over later call if the priority setting
*
is the same. When the communication path is occupied,
it is notifi ed by a sound.
Communication takes priority over calling.
*
However, when a call with higher priority comes in, the
communication will be forcibly stopped.
With an IS-MV, you can select the desired one from the
*
list of currently received calls, etc.
*
2
: [BROADCAST]:
This can be selected only when you perform paging.
When [BROADCAST] is selected, you can perform
paging while interrupting all the other communications of
lower priority. In that case, no receiver can answer you.
NOTE:
When communication is stopped by receiving a higher priority
operation, a notice sound rings.