Filter
Top Products
Settings
49
Choosing the incoming call signalling method
During a call, you can choose to use a beep to tell you when you receive a new incoming call.
1 - Press the Funct interactive key.
2- Press the Program interactive key.
The display shows «WHAT DO YOU WANT TO PROGRAM?».
3- Press the Signal interactive key.
The display shows the signalling status: activated or
deactivated.
4- Press Modify interactive key.
The display shows the new signalling status for incoming calls.
Depending on the settings, an incoming call triggers a beep and
the lamp flashes.
Signal
Funct.
Program
Modify
3- Press the Melody interactive key.
The display presents two signalling modes.
. You want to inhibit the ring,
press the Chut interactive key.
. You want to replace the melody by beeps,
press the Beeps interactive key.
To restore the ring, you have to press the Normal interactive
key.
Chut
Beeps
Melody
With the set idle,
- Consecutively press keys or to decrease or increase the
key beep volume.
Each time pressed, the new setting is broadcast.
The last setting made remains stored by the set.
Adjusting the key beep volume
Each time a key is pressed, a beep is given. The volume of this beep can be adjusted to 8
levels. The lowest level corresponds to elimination of the beep.