Filter
Top Products
41
The multikey function
41
By default, an attendant console has a single directory number* but has six customized keys
allowing it to handle several calls in parallel (CCO1 to CCO6).
You can increase the number of programmed keys or CCO. The new CCO programmed keys are
used in exactly the same manner as that described in the section § Using the attendant console.
Example: to cope with eight calls at the same time, you will need to program the multikey
function on an additional two keys.
The multikey function
1 - Press the Funct. interactive key.
2- Press the Program interactive key.
The display shows «WHAT DO YOU WANT TO PROGRAM?».
3- Press the Key interactive key.
The display asks you to select a programmable key.
4- Press a programmable key.
The lamp associated with this key illuminates steadily, and the
display shows the programming status of the said key.
5 - Press the Modify interactive key.
The display shows «WHAT DO YOU WANT TO PROGRAM?».
6- Press the Superv. interactive key.
The display asks «WHAT DO YOU WANT TO SUPERVISE?».
7- Press the Extens. interactive key.
The display asks if you wish to supervise your set or another set.
8- Press the Yes interactive key to supervise your set.
The display shows the number of keys already programmed for
this function (by default, 6 on an attendant console).
9- Press the Add interactive key to accept the new
programming.
10 - Press the <-Start interactive key, and then proceed
to program the multikey function to at least one other
customizable key.
Note: use the red key to cancel a setting or return to the
idle screen.
Programming the multikey function
Key
Modify
Superv.
Extens.
Yes
Suppose you wish to program the multikey function.
Funct.
Program
Add
<-Start
* Depending on the features provided by your system operator