Filter
Top Products
13
Setting the date and time
If you subscribe to the Calling Line Identification service from your telephone company,
the date and time are set automatically after you receive your first incoming call. If you do
not subscribe, you must set the date and time manually
To resume the automatic date and time setting (if the date and time has been set manually),
disconnect the power supply, then re-connect it. After your first incoming call, the date and
time are automatically set if you subscribe to the Calling Line Identification service from
your telephone company.
Turning the ringer on and off
Note: Do not lift the handset while you are turning the ringer on or off.
To set the date and time:
1. Press the Set Options key.
2. Press • to enter the Options List.
3. Press
– or ‚.
4. Press
‚ and follow the instructions on the display.
5. Press
®.
To turn the ringer on: To turn the ringer off:
1. Press
√. 1. Press √.
2. Press
¬. 2. Press ¬.
3. Press the right side of
√. Con-
tinue pressing the right hand side until
you reach the desired ring volume.
3. Press the left side of √. Con-
tinue pressing the left hand side until
the ringer is off.
4. Press
ß. 4. Press ß.
Ringer is OFF and the line affected
appear on the display.
P0844339 04 E UG 9417CW Page 13 Thursday, April 20, 2000 11:09 AM