Filter
Top Products
Supplementary features
25
■
Requesting a Callback
You want to talk to a certain person. The person is busy or does not answer. You can make call-
back requests to both internal and external subscribers. Not all providers support this function.
If the called party is busy, you can activate an automatic callback. In this case, your phone will
start ringing as soon as the party you are trying to reach goes on-hook. When you pick up the
handset, the person you want to call is dialled directly.
If the called party does not answer, you can also request a callback. The subscriber then obtains
a message indicating your callback request on his display.
■
To answer the callback request
Someone has asked you to call back. You can tell this from the lit attention LED in the idle state.
The display reads Call back requested...
Pick up the handset.
➞
The phone number is dialled.
Note:
To find out how to configure a configurable key, refer to the Chapter "Config-
uring Keys", 63.
You called someone and hear the busy tone or the ring-back tone.
Callback
To activate a callback request:
Press theCallback Foxkey.
Put the handset on-hook.
➞
The display shows Call expected...
End
Back to the idle state:
Press the End Foxkey.
➞
Callback remains activated.
Reset
Reset callback:
Press the Reset Foxkey.
➞
Callback is deactivated.
Note:
You can only have 1 callback activated at a time and only 1 callback can be
expected from you. Your callback request will automatically be cancelled by
the system after about half an hour.
Call
Press the Calls Foxkey.
➞
The phone number is dialled.
Note:
You can deactivate a requested callback using Menu > Activated features >
Reset Foxkey.
eud-0830_en.book Page 25 Wednesday, January 24, 2007 2:00 PM