RTM-ATCA-SXXX Overview
6806800H62B ATCA‐S201InstallationandUseGuide42
CLI command syntax
Table 19 CLI command syntax, set network property: assign NTP server
Convention:
atca_blade set_network Y 10+ <server1> … [server5]+
<server1>
… <server5>
Enter one to five NTP servers, specified as Dotted decimal or domain addresses
(time.nist.gov)
4.6.8 Network time protocol - NTP (On/Off)
<Read/Write> Users may enable NTP protocol service to synchronize the ATCA-
S201’s clocks with a known good reference time source.
4.6.9 Ethernet network port identification
The ATCA-S201 provides multiple Ethernet interfaces that host blades may use to
access storage. Whether using the CLI or web based configuration tools, these
ports are identified with the Linux resource labels shown in the table below
Table 20 Ethernet ports for chassis communications (base/fabric)
Linux interface identifier Port Description
/dev/eth0 10/100/1000 — Base 0 (Zone -2)
/dev/eth1 10/100/1000 — Base 1 (Zone -2)
/dev/eth2 10/100/1000 — Management (RTM, Rear I/O management
port)
/dev/eth3 10G — Fabric 0 (Zone-2 XAUI )
/dev/eth4 10G — Fabric 1 (Zone-2 XAUI )
The webtool provides a table for each Ethernet resource. Users may enter new settings for any field,
and click the submit button located at the top of the screen to apply the settings.
Management[eth#] Network configuration
IPAddr ess NetworkMask Broadcast Gateway MTUSize MACAddress
ActiveSettings 192.168.200.32 255.255.255.0 192.168.200.255 192.168.200.1 1500 00:11:0D: x x: x x :x x
NewSettings DHCP Enable
dhcp 1500
0.0.0.0
0.0.0.0
0.0.0.0
