RTM-ATCA-SXXX Overview
6806800H62B ATCA‐S201InstallationandUseGuide34
4 Network configuration
1
RS232
Console Setup
2
Ethernet
Comm. Setup
3
RAID
LUN Setup
4
Logical Volume
Setup
5
iSCSI
Device Setup
6
NFS / SMB
Share Setup
Configuration Step:
This chapter explains how to configure the IP ports for external host access. The
ATCA-S201
offers 5 Ethernet ports within the ATCA environment, as follows:
Two 10Gb XAUI fabric ports (zone-2)
Two 1Gb base ports (zone-2)
One 1Gb management port (zone-3)
iSCSI & NAS
AMC disk
modules
HW RAID
Physical
disks
sda
sdb
sdc
Zone-2 Fabric
Zone-2 Base
Zone-3 RTM
IP network
IP host
1:1 mapping (JBOD)
1:1 mapping (JBOD)
Site: B1
Site: B2
Site: B3
Site: B4
Logical
groups
&
volumes
vgz
vga
CIFS
share points
NFS
share points
iSCSI
LUNs
2
Storage is ultimately served out over these IP ports using iSCSI, NFS and SMB protocols.
Administrators may individually enable and configure these ports. Configuration can be
done using the serial console port, Telnet or via HTML. This chapter assumes the reader is
familiar with internet protocols and TCP/IP networking.
Note: This chapter provides how-to-use details for the secure web configuration
tool. Optionally, the user may perform configuration by establishing a login session
from a secure shell (ssh) window, and running the command line utility (CLI). Refer
to section 3.4.5, titled Command line configuration tool for more information.
