Filter
Top Products
13
Making Calls- - - - - - - - - - - - - - - - - - -
1. Pick up the handset and press
PHONE.
2. When you hear a dial tone, dial the
number.
3. The indicator for IN USE (on the base
unit and handset) will light. If you
make a mistake when dialing, press
OFF to hang up, then press PHONE to
get the dial tone again.
You must always press PHONE before you can dial a call on the handset.
Answering Calls
1. When an incoming call is ringing, the IN USE LED in the base and the IN USE LED
in the handset will flash. To make sure your phone rings when the handset is away
from the base, please keep the base antenna in the upright position.
2. To answer a call when the handset is in the base, just pick up the handset.
3. To answer a call when the handset is away from the base, just press any key on the
handset (EXCEPT OFF). This is very useful in a dark environment; you do not have
to fumble around looking for the PHONE key to answer the call.
Disconnecting
To end a call, either place the handset
back in the base, or press OFF on the
handset.
Changing Channels- - - - - - - - - - - - -
If you notice interference when using
your handset, press CHAN to switch to a
clear channel. This function is only
available when you are on a call.
TONE/ PULSE Setting
If you have touch tone service on your
line, Press PROG, *,*,MEM to switch to
TONE dialing. If you have rotary service,
press PROG,*,#,MEM to switch to
PULSE dialing.
NOTE: Your VT9151/VT9155 is preset
at the factory for TONE dialing.
OPERATING INSTRUCTIONS
MAKING CALL
and
ANSWERING CALL
TO END
THE CALL
CHANGING
CHANNELS
TONE / PULSE
Setting