Filter
Top Products
Selecting a Preset OGM
After you have recorded an outgoing message, you can set your Answering
System to play either a preset message or your outgoing message.
1.
Press
ogm.
Your recorded outgoing
message will begin to play.
2.
While your recorded outgoing message is playing, press
ogm
again.
A tone will sound, and you hear the preset message “Hello. No one is
available to take your call, please leave a message after the tone” on
the Base Unit speaker. A second tone sounds after the preset message
plays, and the Answering System automatically returns to Standby.
Note:
If
the
REC
TIME/ANN/4/1
switch is set to Announce Only, then
the preset message “Hello. No one is available to take your call” is
played.
3.
To select your recorded
message again, press
ogm
The preset message
will
begin to play on the Base
Unit speaker.
4.
While the preset message is playing, press
ogm
again.
A tone will sound, and your recorded message
will
play on the Base
Unit speaker. A second tone sounds after your message plays, and the
Answering System
automatically
returns to Standby.
Setting the Toll Saver Switch
The Ring
Number/Toll
Saver switch allows you to set the number of
rings
the caller hears before your Answering System answers. You can set the
switch to answer after 2 rings or after 4 rings. In the TS (Toll Saver) position,
the Answering System answers after two rings if you have messages
recorded, and it answers after four rings if there are no new
messages
So if
you call long distance to check your messages,
second ring and not be billed.
you can hang up
after
the
*Note;
For the New Zealand Model, when in the TS
(Toll
Saver) position, the an-
swering system answers after six (6) rings if there are messages and
nine (9) rings if there are no new messages.
49
50