Filter
Top Products
If the
talk/batt
low
LED begins to flash, the phone is programmed to limit its
functions to save power. The table below describes what to do to return your
phone to normal operation.
DURING A CALL
IN STANDBY MODE
1
Adjusting Ringer/Volume Controls
Handset Ringer Control
Only the talk button operates.
The Handset beeps and the
talk/batt
low
LED flashes once
everv 3 seconds.
None of the buttons will operate.
The Handset
talk/batt
low
LED
flashes once every 3 seconds.
Complete your call as quickly as
possible.
You will not be able to make a call.
Return the Handset to the Base
Return the Handset to the Base
Unit for charaina.
Unit for charaina.
I
Note:
Allow 15
to
20 hours without any interruption for
the
Handset to
fully
recharge.
Setting the Pulse/Tone Switch*
Be sure the PULSE/TONE switch is in the TONE position.
Note: Most phone systems are Tone dialing. Check with your local phone
company if you are not sure whether your system is Tone or Pulse
dialing.
*
The New Zealand model is a tone only telephone and the Pulse/
Tone switch has been disabled.
You can also select the ringer
tone or ringer volume for the
Handset.
Press
ringer
to select a
different ringer tone or ringer
volume when the phone is
not in use.
Base Volume Controls
1
4
Handset Ringer Tone Select
Button
To adjust the Base Unit
ringer volume, move the
RING
VOL-OFF
LO H/ switch to
the desired setting.
25
26