Filter
Top Products
Changing Channels, Flash, and Page/Find
Programming Your Phone
To change channels or access call waiting while the phone is in use, or to
use the one-way page to locate the Handset, follow these steps:
I
HANDSET
I
BASE UNIT
CHANGING
CHANNELS
FLASH
-OR-
Press
@
Note: Change channels to
help eliminate background
noise.
If the
call
waiting
tone
sounds, press
@to
accept
the waiting call.
If you have finished a call
and want to make another
call, press
@I
to hang up
and aet a dial tone.
Note: You must use the
Handset to change
channels.
Note: The Base Unit does
not have
8.
You must use
the Handset for
call
waiting
and to make a call.
PAGE/FIND
Note: When
page/find
is
Press
page/find
on the
pressed on the Base Unit,
Base Unit to locate the
the Handset
beeps.
Handset.
Note: If you do not have any special phone service, pressing FLASH
might
1.
Remove the Handset from
disconnect the current call.
the Base Unit.
If
the above FLASH operation does not work and you have the
“Easy
Call”
service connected then
follow
your service provider’s instruction to
operate
“Call
waiting’:
2.
Press
@
.
The
talk/batt
low LED blinks.
For convenience, the Handset has ten memory locations so you can store
the numbers you use most often in either place. Just remember that all
programming functions must be completed when your phone is in the
standby mode, since the programming keys do not function while you are on
the phone.
Storing a Number in Memory
Use these keys
to store a
number in
memory with the
Handset.
Note: An error
tone
will
sound
and the
programming
procedure will be
canceled
if more
than
20
seconds
elapse between
each keystroke
entry
or step.
31
32