Filter
Top Products
GETTING STARTED
GETTING STARTED [ 9]www.uniden.com
• Use only the Uniden
(BT-909) rechargeable
battery pack
supplied with your
cordless telephone.
• Replacement batteries
and/or rubber seals
are also available
through the Uniden
Parts Department at
(800) 554-3988,
Monday thru Friday
from 8:00 a.m. to
5:00 p.m. or online
at www.uniden.com
B. Activate the handset before charging the battery
The handset is powered by a rechargeable battery pack already
installed in the handset’s battery compartment. Before
charging the battery for the fist time, push the pin for
activation, located on the bottom of the handset (see label
with instructions). Once activated, remove the label and then
place the handset in the base unit to charge.
Make sure to charge for 15-20 hours without interruption (do
not plug the telephone cord into the unit and wall jack during
charge time). The base unit’s LED light labeled (
charge/in
use
) illuminates once the handset is placed in the base. The
LED light will illuminate regardless if the battery pack is
connected or not.
If the base
charge/in use LED light does not illuminate:
• Check to see if the AC adapter is plugged into the base unit
and the electrical wall outlet properly. (Use only the
supplied AC adapter. Do not use any other AC adapter.)
• Check to see if the handset is sitting correctly in the base.
UC393BH (WXI377) OM 5/2/03 4:18 PM Page 9