Filter
Top Products
GETTING STARTED[ 10 ] www.uniden.com
Replace the rechargeable handset battery pack
1) Remove the 3 screws holding the battery compartment with a
screwdriver and take off the battery cover. Remove the old
battery pack in the battery compartment.
2) Plug the replacement battery connector (red & black wires)
into the small, black jack inside the battery compartment.
(The connector notches fit into the grooves of the jack only
one-way.) Match the wire colors to the polarity label in the
battery compartment, connect the battery and listen for a
click to insure connection.
3) Make certain you have made a good connection by slightly
pulling on the battery wires. If the battery connector is not
securely connected, the handset will not charge properly.
4) Before placing the battery cover back on the handset, make
sure there is no foreign matter under the rubber seal located
on the under side. By inserting bottom first, place the
battery cover back on the handset and tighten the 3 screws.
• If there is any foreign
matter on the rubber
seal located on the
under side of the
battery cover, the
handset may not be
water resistant.
• The rubber seal should
be kept clean and
replaced every 2 years
to ensure the handset
is water resistant even
if the seal does not
look worn.
Do not place a wet or
dirty handset in
the base.
Rubber Seal
UC393BH (WXI377) OM 5/2/03 4:18 PM Page 10