Uniden WXI377 Cordless Telephone User Manual


 
GETTING STARTED
GETTING STARTED [ 17]www.uniden.com
Make sure your battery
pack is fully charged
before choosing the
dialing mode.
Choosing the dialing mode
Most phone systems use tone dialing which sends DTMF tones through the phone
lines. However some phone systems such as in rural areas still use pulse dialing.
The default setting is tone dialing. Depending on your dialing system, set the mode
as follows:
1) When the phone is in the standby mode, press and hold
cid/menu. The following screen appears.
2) Press
4 or the vol/- key three times to select Dial.
3) Press
select to toggle between Tone and Pulse for
each setting.
4) Press
end or return the handset to the base unit to complete the setting.
The handset returns to the standby mode.
If you are not sure of your dialing system, set for tone dialing. Make a trial call.
If the call connects, leave the setting as is, otherwise set for pulse dialing.
If your phone system requires pulse dialing and you need to send the DTMF tones for
certain situations during a call, you may switch-over to tone dialing. (Refer to
Tone Dialing Switch-over on page 21.)
UC393BH (WXI377) OM 5/2/03 4:18 PM Page 17