ADDITIONAL INFORMATION [ 37]www.uniden.com
ADDITIONAL
INFORMATION
• To protect you against
misbilled calls which
might result from your
phone being activated
by other equipment,
the cordless phone has
AutoSecure
TM
feature
electronically locks
your phone when the
handset is in the base.
Also, the Random
Code
TM
digital security
which automatically
selects one of over
262,000 digital
security codes for
the handset and base.
• If the handset battery
pack is completely
discharged or the
battery pack is
removed, the digital
security code will be
lost. If this happens,
a new security code is
set automatically the
next time the battery
pack is charged.
Changing the Digital Security Code
The digital security code is an identification code used to connect the handset and
the base unit. Normally, setting the code is not necessary. The first time you charge
your handset, the security code is automatically set.
In the rare situation that you suspect another cordless telephone is using the same
security code, you can change the code.
1) Remove the handset from the base unit. Press and hold
find handset on the base.
2) While holding
find handset, place the handset in the base unit, and leave the
handset in the base for more than 3 seconds. A new random security code is set.
Installing the Beltclip
To attach the beltclip
Insert the beltclip into the holes on each side of the handset. Press down until it clicks.
To remove the beltclip
Pull both sides of the beltclip to release the tabs from the holes.
UC393BH (WXI377) OM 5/2/03 4:19 PM Page 37