GETTING STARTED[ 12 ] www.uniden.com
• Place the power cord
so that it does not
create a trip hazard or
where it could
become chafed and
create a fire or
electrical hazard.
• The base is not
water resistant. Also
wipe off a dirty or
wet handset before
placing in the base.
• Use only the
supplied AD-0002
AC adapter. Do not
use any other
AC adapter.
• Connect the AC adapter to a continuous power supply.
• Place the base unit close to the AC outlet so that you can unplug the AC adapter easily.
C. Connect the base unit
1) Connect the AC adapter to the DC IN 9V jack
and to a standard 120V AC wall outlet.
2) Set the base on a desk or tabletop, and
place the handset in the base unit.
3) Make sure that the
charge/in use LED illuminates.
If the LED does not illuminate, check to see that the AC adapter is plugged
in and that the handset is sitting correctly in the base.
Route the cord.
• After activating the handset, charge your handset at least 15-20 hours before
plugging into the phone line
.
4) Once the handset battery pack is fully charged,
connect the telephone line cord to the
TEL LINE jack and
to a telephone outlet.
Modular
If your telephone outlet isn't modular,
contact your telephone company
for assistance.
UC393BH (WXI377) OM 5/2/03 4:18 PM Page 12