Filter
Top Products
I
1I
I
I
I
;
i
I
I
I
i
I
I
!
i
I
I
)
To program:
1. Press the @l) Key for about 1.5 sec.
Two beeps will be heard and the lCD displays:
[ --]
2. Press the @ Key. The PRI indicator appears on the
lCD display and flashing.
, I I"
PAl -
...I I ..
8:»..
3. Select the lead-In Tone you want to use.
Example:
Selecting the Tone assigned to digit 1.
Press (D. The lCD displays:
-
, I I"
PAI-
I ..
-I
3. Pressthe@l) Key to complete the programming.
Two beeps will be heard and the lCD returns to its
previous status prior to accessing Programming Mode.
To remove the lead-In Tone:
1. Follow steps 1 and 2 of lead-In Tone Programming.
2. Press and hold @l) Key for about 1.5 sec until you hear
the two beeps. the lCD will display "E" Tone but it will
not be programmed to the memory.
Be careful not to press the @l) key twice.
Otherwise, "E" tone will be programmed as your lead-In
Tone.
Note: Make sure that all members of your group will use
the same Lead-In Tone. Else, you will lessen the
probability of receiving and successfully decoding a
se/call call while TSQ Scanning.
Page 33
UH-O57