Filter
Top Products
@)
@
<ID
@
---
r
: ENTER Key; Pressto enter the selected
Channel;
: Press to store the
RXITXCode, lead-In
Tone, lead-In delay,and Tone Period
Setting when programming
: Press and hold for 1.5sec to enter special
programming modes.
: Assigned as "E" tone when programming
lead-In Tone ONLY.
: TONE CALL Key; Press and hold for about
1.5 sec to transmit the transmitter ID (e.g.,
calling other radio by transmitting its
SElCAll ID)
: Assigned as "A"tone when programming
RX ID, TX ID or lead-In Tone.
: TONE SQUELCH Key; Press and hold for
about 1.5sec to putthe receiver on "Quite"
Mode.
: Assigned as "B" Tone when programming
RX ID, TX ID, or
lead-In Tone.
: PRIORITY Key; Press this key to store or
remove the selected Priority channel tot
from the memory buffer.
: Assigned as "C"tone when programming
RX ID, TX ID, or lead-In Tone.
Note: Whenshipped fromthe factory,no SELCALLcodes
are stored in the memory. Errortone will be heard
everytime @ or @ Key is pressed. Toprogram,
please see page 27.
UH-O57
See page 34 forNumericKeypad SELCALL Tone
Assignment.
Page 12