Filter
Top Products
[ 45 ]
THE INTEGRATED
ANSWERING DEVICE
Remote access away from home
You can operate your answering system from a remote location using any
touch-tone telephone. Use this function to check for recorded messages, to
play or delete messages, to record a new outgoing message, and to monitor
sounds in the room.
1 Call your telephone number.
2 While the greeting message is played, press # and your PIN code within
2 seconds.
If the answering system is off, let it ring 10 times. The tone sounds.
Then, press # and your PIN code within 2 seconds.
3 The answering system announces the time and day and the number of
messages stored in memory. Then the message playback automatically begins.
4 You may continue to listen to your message, or you may select a command
from the following chart.
5 After all of your messages have played, or the playback time exceeds 4
minutes, you will hear intermittent beeps indicating that the system is in
the command waiting mode. You may enter another command at this time
from the chart above.
• During the remote
operation, displays
on the base.
• You must enter a
command within 15
seconds of entering
command waiting
mode. Otherwise the
answering system
automatically hangs up
and returns to standby.
• The system will only
playback messages for
four minutes and then
it returns to command
waiting mode. To
continue playing your
message, press # then
2 again within 15
seconds.
Command Function
# then 1 Repeat a message
# then 2 Playing your messages
# then 3 Skipping a message
# then 4 Deleting a message
# then 5 Stop message playback
# then 6 Answering system on
# then 7 Voice memo record/stop (up to 4 minutes recording time)
# then 8 Greeting message record/stop
# then 9 Answer system off
# then
*
Room monitor
THE INTEGRATED ANSWERING DEVICE
TRU548 ENG O/M 7/18/01 15:43 Page 45