Filter
Top Products
GETTING STARTED[ 10 ]
D. Choose the dialing mode
Most phone systems use tone dialing which sends DTMF tones through the
phone lines. However some phone systems still use pulse dialing such as in
rural areas. The default setting is tone dialing. Depending on your dialing
system, set the mode as follows:
•If you are not sure of your dialing system, set for tone dialing. Make a trial
call. If the call connects, leave the setting as is, otherwise set for pulse
dialing.
• If your phone system requires pulse dialing and you need to send the DTMF
tones for certain situations during a call, you may “switch-over” to tone
dialing. (Refer to “Tone Dialing Switch-over” on page 19.)
If your dialing system is Set the switch to
Tone TONE
Pulse PULSE
TRU548 ENG O/M 7/18/01 15:39 Page 10